Valco Baby Latitude Peg Perego Adaptor - Manual (Page 4)

WARNINgs
•Always follow car seat manufacturers instructions when in use.
•Be sure to check that all straps and buckles are securely fixed and in place
before use.
• Check all parts for breakage or fatigue before use. Discontinue immediately if
any part is found to be damaged or broken.
• NEVER leave any child unattended at any time.
• This product is intended for use in North America only. It is not intended for
use in Australia.
• This product is intended for domestic use only. It is not intended for
commercial use.
In North America only
www.valcobaby.com
1 800 610 7850
6
7
FIgURE I
16. Once your car seat is inserted, locate the
remaining set of straps.
17. Take the Male/Female strap and slip the
strap through the car seat belt hook on the side
of the car seat.
18. Repeat with the other strap.
19. Insert Male clip into its Female counterpart
and buckle.
20. Adjust straps to tighten around car seat.
TO REMOVE yOUR CAR sEAT:
21. Reverse the steps outlined in Figure I and
lift out the car seat.
TO REMOVE yOUR ADAPTOR:
22. Undo the buckle under the footrest, slide
the connector pieces from the stroller and
remove adaptor.
I