Valco Baby Latitude Peg Perego Adaptor - Manual (Page 3)

E
H
FIgURE E
6. Align an adapter connector piece with the
corresponding raised piece on the stroller
(where the hood connects) (4).
7. slide the connector piece onto the stroller. Be
sure that the adapter is locked into place (5).
8. Repeat on the other side.
FIgURE F
9. The Adaptor is now secured to the frame,
with the support bar resting at the edge of the
seat, above the footrest.
10. Adjust the footrest upwards.
To do so: Press the adjust button, and move the
footrest to the desired position.
FIgURE g
11. Located on the car seat adaptor are two
sets of tether straps. The first set (as shown in
Figure g) rest on the foot rest of the stroller.
Adjust these straps so they wrap underneath
the foot rest of the stroller.
12. secure by inserting the male clip into the
female end. Ensure these straps are as tight as
possible.
13. The adaptor is now securely attached to
your stroller. you may readjust the footrest to
suit your child.
FIgURE H
14. Position the Car seat so the infant is facing
the handlebar of the stroller.
15. Line the Car seat up with the adaptor bar
so that the Car seat rests on the adaptor bar
when inserted.
5
4
Press F
g