Valco Baby Tri Mode Twin SE - Manual (Page 6)

Using yOUr brakes
FIGURE Q
36. To engage: Press down on the centre pedal until the brake pins
engage in the nylon brake cogs in the wheel hub.
IMPORTANT: ALWAyS ChECk ThAT ThE bRAkE hAS ENGAGED
bEFORE USE, IF NOT yOU MAy NEED TO MOvE ThE STROLLER
FORWARD OR bACk SLIGhTLy UNTIL IT LOCkS INTO PLACE.
37. To disengage, lift the centre pedal upward till it locks in the
upright position.
FOlding the strOller
FIGURE R
38. Fold the hood back up against the handle.
39. Release the locking clamps at either side of the stroller.
40. Simultaneously lift the secondary safety catch (located at the
left hand side of the stroller while standing behind) and swing
the handle forward.
FIGURE S
41. Holding the rear legs at both sides, press down with
your foot on the rear basket tube. This will disengage the
basket frame locking hinges.
42. Continue pushing the rear of the basket, moving the
rear wheels forward beneath the frame.
43. You can lock the frame closed by stretching each
locking strap (located at either side of the chassis)
over the frame, placing each catch over the rivet on the
chassis.
Opening the strOller
FIGURE T
44. To open, unlock each locking strap by pushing
downward in the catch till it disengages from the rivet
head.
45. HINT: if the strap is too tight to release, push the
handle bar downward to assist in fastening and
releasing the locking strap.
46. With your foot on the inside of the rear wheels,
stopping them from moving, lift the handle upwards. (This will
open the chassis and begin to move the rear wheels away from
the front wheels.)
47. Press down on the basket frame locking hinges to lock the
frame in the open position.
48. Secure the handle to the frame by engaging
the locking clamps on both sides.
IMPORTANT WARNING: ALWAyS TEST ThAT ALL
AXLES, WhEELS, FRONT bAR, hINGES AND LOCkS
ARE SECURELy ENGAGED bEFORE USE.
Q
R
44
45
S
T