Valco Baby Tri Mode Twin SE - Manual (Page 4)

installing the eXpanda hOOds
FIGURE H
18. Identify left and right side hoods by determining that
the sliding housing (Image K) sits on the SIDE (a) of the
frame, and the puzzle housing (b) (Image J) rests on the
centre (c) of the stroller.
FIGURE I
Turn your stroller around to the back:
19. Place the rear hood skirt OVER the stabilizer bar at the
rear of the stroller (d).
FIGURE J
Turn your stroller around to the Front: [SEE IMAGE H (c)]
20. Insert the hood section (e) into the corresponding
housing (f) in the CENTRE of the seat.
FIGURE K
21. Place the other plastic hood housing above the
corresponding housing on the SIDE of the stroller. Be
sure that the frame locking strap is out of the way and
ABOVE the hood housing.
22. Align the raised track on the stroller housing with the
corresponding channel in the hood housing.
23. Slide the hood housing downward, engaging the track
in the channel, continue sliding downward until the rivet
outside (g) is fully engaged in the housing.
24. Repeat the procedure outlined in Figure J to K for the
other hood.
FIGURE L
25. Secure each hood to the rear of the frame with Velcro
straps at the centre (h), and both sides of the hood (i).
d
I
J
e f
K
L
g
i
i
h
a
b
H
c