Trail Master Suspension TM401_TM401N 2004– 2013 FORD F-150 2WD/4WD 2.0 FRONT SPACER KIT - Manual (Page 4)

TM401 & TM401N
Revised
8.9.13
4
Install Front
Suspension
1. Remove the front wheels.
2. Work on one side of the vehicle at a time.
3. Remove the dust cap from the hub.
4. Unbolt the OE brake line, ABS line and
brackets from the side of the knuckle. Save
the hardware for reinstallation.
5. Remove the vacuum line from the back of the
hub.
6. Remove the tie rod end nut and separate from
the knuckle using the appropriate tool.
7. Remove the front caliper and bracket assem-
bly from the front knuckle by removing the
(2) retaining bolts.
NOTE: Make sure you do not let the
calipers hang on the brake lines or damage
will occur.
10. Remove the front rotors from the front hub.
8. Remove the backing plate bolt from the
knuckle to access the ABS sensor.
9. Unbolt the ABS sensor from the hub.
10. Unbolt the sway bar from the sway bar end
links. Save hardware for reinstallation.
ABS
Sensor
Tie Rod end
Brake
Caliper
ABS Line
Bracket
Brake Line
Bracket
OE Backing
Plate Bolt