Syba SY-UEN-35-NF - Manual (Page 5)

polarity is not correct, you can damage the electronic section of the
3.5’’ enclosure.
Notice: For all existing storage devices such as 3.5’’ IDE hard
drives, please make sure the JUMPER setting set to
MASTER before installing into 3.5’’ USB 2.0 Enclosure.
(However, for certain hard drives, you may need to set
the jumper as “Cable Select”.)
SOFTWARE INSTALLATION
Note: This software installation section assumes that your
computer system already has USB 2.0 ports available for
connecting the 3.5’’ enclosure and all the appropriate drivers
have been property installed.
A. Installing USB 2.0 driver
For Windows 98/98SE
Windows 98/98SE does not include a USB Mass Storage
driver so you need to install Windows 98/98SE driver. The
driver is located in \Prolific\PL2506_2507 directory of the