CyberPower Systems PR1500 User Manual
Page 15

PR1500/ PR2200
Guaranteed Uninterruptible Power System
In the event of damage to the Connected Equipment, your exclusive remedy, and 
CyberPower's sole obligations are as follows for Connected Equipment. If (a) the Product 
purchased and owned by you is defective in material or workmanship; (b) the Limited 
Warranty requirements have been met (except that the three year limitation of the Limited 
Warranty does not limit the Power Control Guarantee, which is for the lifetime of the 
Product), and; (c) none of the limitations or exclusions on warranty coverage apply (or than 
the three year limit), CyberPower will (as CyberPower elects, as permitted by law), repair, 
replace, or pay the Agreed Damage Amount (defined below) for, the item(s) of your 
electronic equipment directly and properly connected to the product (the "Connected 
Equipment") if that Connected Equipment is (x) damaged by AC power line transients, 
spikes, or surges on properly installed, grounded, and code-compliant 120 volt power lines 
in the United States and Canada, or by transients, surges or spikes on standard telephone 
equipment lines, or Base 10/100T Ethernet lines that are properly installed and connected 
(a "Power Disturbance") and (y) is directly plugged into and properly connected to a 
CyberPower Product in its original condition which is properly operated when a Power 
Disturbance passes through the CyberPower Product and (y.1) exhausts the protection 
capacity of the CyberPower Product or (y.2) damages the CyberPower Product. This 
provision sets out the only liability of any character of CyberPower for direct, indirect, special, 
consequential, and/or incidental damages under our Limited Warranty, applies only to 
Connected Equipment, and all such Liability is limited to the Agreed Damage Amount. 
 
Making a Power Control Guarantee Claim.
 
To make a Warranty claim for damage to Connected Equipment under the Power Control 
Guarantee, you must do the following: 
 
1. Complete and return the CyberPower Warranty card or provide reasonable proof of 
purchase, for example, a sales receipt that establishes you as the original end-user 
consumer purchaser of the Product. 
2. Call CyberPower at (952) 403-9500 or (877) 297-6937 (toll free), write to CyberPower 
at 5555 12th Ave East, Suite 110, Shakopee, MN 55379, or e-mail CyberPower at 
[email protected] within ten (10) days of the date of the event for which 
you wish to make a claim for warranty service. 
3. When you contact CyberPower, identify the Product, the Purchase Date, and the 
item(s) of Connected Equipment. Have information on all applicable insurance or other 
resources of recovery/payment that are available to the Initial Customer and the name of 
the power utility supplier for the location of the Connected Equipment and Request a 
Return Materials Authorization (RMA). 
4. Pack and ship the product to CyberPower and, if requested, the item(s) of Connected 
Equipment, a repair cost estimate for the damage to the Connected Equipment, and all 
claim forms that CyberPower provides to you. Show the RMA number on the shipping 
label or include it with the product. You must prepay all shipping costs, must pay the 
cost of the repair estimate and is responsible for packaging and shipment. 
 
CyberPower’s Duties. 
 
CyberPower will inspect and examine the Product and the item(s) of Connected Equipment 
(or at CyberPower's election, your written statement and repair cost estimate for those 
item(s)). You must return the product for inspection. 
 
If the damage to Connected Equipment is covered by the Power Control Guarantee, 
CyberPower will (in addition to Limited Warranty remedies for the CyberPower Product itself) 
repair (or pay the costs of repair) or replace the Connected Equipment or, at the option of 
CyberPower, as permitted by law, pay to the Initial Customer the "Agreed Damage Amount" 
(up to the aggregate limits stated below) for all item(s) of Initial Customer's Connected 
Equipment. The "Agreed Damage Amount" for all items of Initial Customer's Connected 
Equipment shall be the lesser of the amount determined under Clause (1) or (2) below, 
reduced by any amounts described in Clause (3) below: 
 
13
