Stealth Cam STC-WD2 I230 - Manual (Page 24)

STC-WD2
www.stealthcam.net Toll Free 877-269-8490 24
mounted camera in the proper position. A green indicator light
on the front will blink on when you have intruded the coverage
area.
• Adjust the camera position as needed and repeat testing until
the desired coverage area is achieved.
• When you have completed the testing the coverage area there
are 2 methods for exiting the test mode:
a. Open the front housing and press the [TEST] button to exit
test mode. The camera will then enter count down mode
for 1 minute and front green indicator will start blinking
giving you one minute to leave the coverage area. Then
the camera will enter PIR detection mode.
b. After 5 minutes in test mode, the camera will then enter
count down mode for 1 minutes and the front green
indicator will start blinking giving you one minute to leave
the coverage area. The camera will enter PIR detection
mode.
Using the camera in PIR detection mode
• Mount the camera to tree or other sturdy object using either