beautypg.com

Wall-mounting the lcr8 – Revel LCR8 User Manual

Page 4

background image

4

Tilting the Speaker

If needed, the enclosed stand allows you to tilt the
speaker across a wide range (i.e., upward to a maximum
of 18° or downward to a maximum of 7°), as shown in
Figure 3.

Important! Do not exceed the tilt range.
Doing so may cause the speaker to fall out
of its stand.

Figure 3

Wall-Mounting the LCR8

Using the Included Wall Bracket

Step One

Remove the wall bracket cover by removing the four
wall-bracket screws on the ends, as shown.

Step Two

Run the speaker wire for the left, center and right channels
behind the wall bracket and out through the holes in the
bracket. After deciding where to place the speaker, attach
the wall bracket (in a horizontal position) to the wall, using
the appropriate screws and anchors.

Step Three

Run the speaker wires out through the holes in the wall
bracket cover. Resecure in place, as shown, with the four
wall bracket screws.

Mounting screws and
anchors not included

Wall bracket

HSGP1054-LCR8_OM 9/12/08 12:42 PM Page 4