Reloop TERMINAL MIX 4 SERATO DJ BUNDLE - Serato Quick Start Guides - Manual (Page 4)

VERSION 1.1.1
DJ-FX
The DJ-FX in Serato DJ are powered by iZotope™. Click the FX tab
to open the FX panel. Select either 1, 2, 3, 4 or M to assign the selected effect bank
to a deck or Master Output. To activate an effect, click the ON button on your FX
UNIT in the software, or the FX1 ON button on your controller. You can adjust effect
parameters by using either software controls, or the FX1/FX2/FX3 knobs/buttons
on the controller.
There are two available modes in the DJ-FX. Single FX Mode allows you to select
one effect per FX bank, and has multiple parameters that can be adjusted. Multi
FX Mode allows you to select up to three effects per FX bank, and adjust only
one parameter, the FX Depth. The same effects available in Single FX mode are
available in Multi FX mode, as well some additional presets.
You can select between the two FX modes by clicking either the Single FX mode
button or Multi FX mode button
Reloop Terminal Mix 2 Control Single FX Mode Multi FX Mode
FXSEL 1 Button Effect On/Off Slot 1 Effect On/Off
FX1 Knob Adjust Parameter 1 Adjust Slot 1 FX Parameter
FXSEL 2 Button Adjust Parameter 2 Slot 2 Effect On/Off
FX2 Knob Adjust Parameter 3 Adjust Slot 2 FX Parameter
FXSEL 3 Button Adjust Parameter 4 Slot 3 Effect On/Off
FX3 Knob Adjust Parameter 5 Adjust Slot 3 FX Parameter
SHIFT + FXSEL 1-3 Buttons Select Effect Select Effect in Slots 1-3
TAP Tap to the desired FX tempo. To return to AUTO mode, press
and hold Tap to the desired FX tempo. To return to AUTO mode,
press and hold
BEATS Adjust Beats Multiplier Adjust Beats Multiplier
*NOTE:* Use SHIFT + RANGE to assign FX UNIT 1 to the Active Deck. Use SHIFT + KEYLOCK to assign FX UNIT 2 to the Active Deck.