Reloop TERMINAL MIX 2 SERATO DJ BUNDLE - Serato Quick Start Guides - Manual (Page 8)

VERSION 1.1.1
# Reloop Terminal Mix
2 Control
Serato DJ Function Shift Modification
20 CUP Stutter Play When in Sync mode, used to disable the Pitch Fader
temporarily and change the zero position
21 CUE Temporary Cue Jump to start of track (more than 2 Sec elapsed) Previous
track (less than 2 sec elapsed)
22 PLAY/PAUSE Play/Pause
23 DECK Select Active Deck 1/3 (Left Deck) or 2/4 (Right Deck)
24 GAIN Adjust channel gain
25 EQ Adjust Low/Mid/High
26 FILTER LP/HP filter combo adjust
27 CUE CHANNEL Cue selected channel in headphones
28 LOAD Load track to selected deck Activate Fader Start
29 CHANNEL FADER Adjusts channel volume
30 MASTER Adjusts master volume
31 BOOTH Adjusts booth volume
32 PHONES Adjusts headphone volume
33 CUE MIX Adjusts between Cue and Master in your headphones
34 SAMPLER VOL Adjusts the master volume of the sample player
35 CRATES Cycle REC/FX/SP-6 Panels Cycle SP-6/FX/REC panels
36 VIEW Cycle view modes Switch between 2 and 4 decks
37 BACK Toggles focus between library/crates/open panels
38 PREPARE Loads track to prepare area Open Prepare Panel
39 TRAX Scroll through currently focused area
40 VU METER LED representation of Master Output
41 CROSSFADER Crossfades between the two channels
NOTE: #28 LOAD When used with SHIFT, activates Fader Start for each deck. This means the track will stop when the channel fader
is down, and the track will start when the channel fader is up. The LOAD button will flash when Fader Start is activated.