beautypg.com

3 troubleshooting, 4 technical specifications, English – Reloop BEATMIX LTD. User Manual

Page 21

background image

21

ENGLISH

6.3 Troubleshooting

If a problem should arise while using Reloop Beatmix the following chart is the first drop-in center:

6.4 Technical Specifications

The following specifications are not verified by Global Distribution GmbH in terms of plausibility and accuracy:

Channel Separation ( crosstalk) : < 70dB
Frequency Response :

20~20KHz (+/- 2dB)

Input Impedance Headphones : 32OM

ANALOG
Master Outputs:

1.0V (+/- 0.2V)

Headphone Outputs:

600mV

THD+N
Unbalanced Outputs:

0.05%

Headphone Outputs:

0.05%

Frequency Response:

20 Hz - 20 KHz (+/- 1.5 dB)

Reloop Distribution

Global Distribution GmbH, Schuckertstrasse 28, 48153 Münster / Germany

Fax: +49.251.6099368

Subject to technical alterations.
Illustrations similar to original product.
Misprints excepted.

SYMPTOMS

POSSIBLE CAUSES

CORRECTIvE MEASURES

The device does not receive any
power.

USB cable is not connected correctly.

Check whether the USB cable is connected to a USB
port of your computer and the USB port of Beatmix
-B33-.

The controller's LEDs are only wea-
kly lit and the device does not react.

The power supply is not sufficient.

Please make sure that your USB port disposes of
sufficient voltage to supply the device with power.

Not all outputs of the integrated
audio interface can be selected in
the DJ software.

The ASIO driver is not installed correctly.

Please install the ASIO driver again. To do so please
also read the paragraph “ASIO Driver Installation” in
the chapter “Computer configuration”.

The audio interface's sound is
distorted.

The ASIO driver is not being used.
The performance settings do not correspond
to the computer's capacity.

Please make sure that the ASIO driver is installed and
is also being used. To do so please read the paragraph
“ASIO Driver Installation” in the chapter “Computer
Configuration”.
It is also possible that in the ASIO driver's settings
the available computer capacity has to be re-confi-
gured. To do so open the Reloop ASIO settings and
increase the “ASIO Buffer”.

There is a problem that is not listed
here.

Various causes.

Visit the website www.reloopdj.com/forum to get sup-
port for your Reloop products.