RCBS Bullet Casting Accessories - Manual (Page 3)

LEAD POT
This large, heavy-duty cast iron pot is used to
melt and blend bullet casting alloys and holds
approximately ten pounds of metal. To use:
Place Lead Pot on most any source of heat
designed to melt lead. Place metal ingots in
the pot and in a few minutes you will have
molten metal ready to cast bullets. The Lead
Pot has a bale handle. The pouring spout minimizes
dripping. Tab lifter can be conveniently gripped with tongs or pliers
when pouring metal. The Lead Pot also has a flat stable bottom to
prevent tipping.
LEAD DIPPER
The Lead Dipper allows easy stirring, scooping and pouring of bullet alloy.
Large capacity bowl holds enough alloy to fill multiple cavity moulds. It
features a comfortable handle that stays cool. The pouring spout is
contoured to fit bullet mould sprues and eliminate air pockets. To avoid
damage, don't apply direct heat to bowl.
INGOT MOULD
Heavy-duty cast iron Ingot Mould forms four,
easy-to-use ingots of bullet alloy. You save
the time of having to mix an alloy every
time you cast bullets. By mixing large
amounts in advance you can have the
correct alloy ready for the next casting
session. The unique design ensures rapid
cooling. The tab lifter can be gripped with tongs
or pliers for ease in handling. Approximate cooling time is ten minutes.