beautypg.com

RCBS Three Way Cutter User Manual

Page 2

background image

If the 3 Way Cutter binds on the case or does not chamfer correctly, condition A may exist, as shown in Figure 1. Loosen the setscrew securing the cutter
head, located on the side of the cutter head carrier. Position the cutter head so the leading edge of the cutter head is lined up just past the tip of the outside
deburring cutter, as shown in condition B, and retighten the setscrew.

Figure 1


If the trim length of the cases begins to vary or the cutter stops trimming and deburring, remove the cutter assembly from the cutter shaft and clean the cutter
by removing any brass shavings that may have built-up on the cutter. The cutting edges should be positioned as show in the drawing below.

Outside 

Deburring

Cutter

Chamfering 

Pilot

Outside 

Deburring

Thumb Screw

Cutter Head

Outside 

Deburring

Setscrew

Customer Service

1-800-533-5000 (US or Canada) or 530-533-5191

Hours: Monday - Thursday, 6:30am - 4:00pm Pacific Time

(hours may vary)

e-mail: [email protected] or visit our website at www.rcbs.com

RCBS 605 Oro Dam Blvd. East Oroville, CA 95965

7200519/1211