RCBS High Capacity Case Trimmer Kit - Manual (Page 6)

- 6 -
CASE LENGTH ADJUSTMENT
1. Shorter
cases, such as the .416 Barrett, require the Collet Holder assembly to be moved closer in towards the
cutter head.
2.
Lock the case into the Collet Holder. The Adjustment Bushing should be positioned in the center of the Cutter
Shaft.
3.
Loosen the 6-32 Socket Head Set Screw with a 7/64 hex wrench and slide the Collet Holder assembly to the right.
Slide the case mouth onto the Pilot while you are pushing the Cutter Shaft assembly to the left to center the case. Tighten
the 6-32 SHSS.
4.
Follow TRIM LENGTH ADJUSTMENT instructions above.