beautypg.com

Spent primer catcher, Troubleshooting – RCBS Mini Grand Instruction Manual User Manual

Page 10

background image

Drain Powder and Shot Hoppers as described above. Unscrew Charge Bar Handle from center of Charge Bar. Slide
Charge Bar out of assembly. Replace Bushing(s). When reinstalling the Charge Bar, be sure that the smaller diameter
Powder Bushing is to the left and the larger diameter Shot Bushing is to the right. Reinstall the Charge Bar Handle.


SPENT PRIMER CATCHER

To empty, simply raise up and off of the mounting screws. Empty into appropriate waste receptacle and replace.

TROUBLESHOOTING


It is normal for certain types of hulls to stick to the Priming Support Rod during the priming operation, simply press down
on the hull mouth and the hull will drop free. This is due to the various inner base wad configurations between
manufacturers.

Bad Crimps are almost always due to using the wrong crimp starter or not having the correct wad. This is frequently due
to incorrect or outdated information found in reloading handbooks or literature supplied by component manufacturers. If
you do not get a good crimp, check your component combination and bushings to insure that they are correct. Crimp is
also selective to the individual user, what looks good or bad to you may be opposite for someone else. Set crimp depth to
your personal preference.