Blaupunkt BOLOGNA RCR 126 - Manual (Page 17)

32
Specifications
Amplifier
Output power:
4 x 20 W RMS power
acc. to DIN 45324
(14.4V),
4 x 30 W max. power
Tuner
Wavebands
FM
: 87.5 – 108 MHz
MW : 531 – 1602 kHz
LW : 153 – 279 kHz
FM sensitivity: 1.0 µ V at 26 dB
signal-to-noise ratio
FM frequency
response:
35 - 16 000 Hz
Tape player
Frequency
response:
35 - 16 000 Hz
Appendix
Overview of the DSC factory
settings
TA VOL : 4
BEEP : 3
LED (Code) : 1
LOUD
: 4
RM : OFF
LOCAL : 1
DIS : 1
Care notes
Release panel
To ensure that the unit functions properly it is
important that the contacts between the re-
lease panel and the head unit are free from
any foreign particles.
If necessary, clean the contacts using a cot-
ton swab soaked with alcohol.
Mechanism/cassette tapes
To avoid possible problems, you should not
use cassette tapes longer than 60 or 90
minutes (C60/C90). Store your tapes in a
cool place away from dirt, dust and tempera-
tures exceeding 50
° Celsius. Allow very cold
tapes to warm up before playing them in
order to avoid uneven tape transport. After
approximately 100 hours of use, dust partic-
les collected on the playback head or roller
may lead to tape run problems and sound
distortions.
Use a head cleaning tape to remove normal
dirt build-up. For tougher cases, use a cotton
swab (Q-Tip) soaked with alcohol. Do not
attempt to clean by inserting a hard object
into the player!
Subject to modifications!
BA Bolo RCR 126 gb® 03.06.2002, 13:38 Uhr 32