Kino Flo ParaZip 400/200 DMX - Manual (Page 7)

7
Pole Operation
Fixture Operation
The Blue cup alters the Pan (left or right.)
The White cup alters the Tilt (up or down.)
Warning! To Ensure Proper Operation
ALWAYS TURN OFF THE FIXTURE BEFORE connecting or disconnecting lamps.
After the lamps are properly installed, the fixture can be turned on. Avoid operating in
temperatures above 125°F (51°C) or below 60°F (15°C).
In temperatures below 60°F or 15°C, the ballast may take longer to strike. If lamps do not
strike within 5 seconds, switch the ballast to OFF, and try again. Check that the lamps are
properly seated and the dimmer is up full, then restrike. If temperatures are too low, try to
warm up the fixture to at least 60°F. Lamps will turn on at preset dimmer settings as long
as the temperature is above 60°F or 15°C.
Warning!
Do not pull yoke to adjust tilt. Turn the white
knob counter clockwise to angle the yoke
90°.
(ParaBeam shown for illustration purposes
only)