Kino Flo Celeb 400Q DMX LED - Manual (Page 13)

13
Troubleshooting
Display Protection Condition Description Normal Condition Cause/Solution
OCP Over Current Protection Shut down current 2.45A
in excess of 20%
2.04A @ 100% dim Repair Service
Center
OVP Over Voltage Protection Shut down voltage @
excess 30V
Below 28V Wrong Battery
or 24V Battery
w/ too high
Open Voltage
UVP Under Voltage Protection Shut down voltage @
below 17V
Excess 18V Dead Battery
OTP Over Temperature
Protection
Shut down temp @
120°C (LDM board side)
Below 120°C @
LED array
Cool Down
OPP Open Protection Open circuit No open Repair Service
Center
SCP Short Circuit Protection Short circuit No short Repair Service
Center
Troubleshooting continued
Can’t set the DMX address.
You must Press and Hold the DMX Address button for 3 seconds in order to se-
lect an address. The display will flash while in edit mode. Select a valid address
from 1-512. (Note: 0 or 513 and higher are invalid addresses.)
Can’t operate the fixture manually with the DMX cable plugged in.
Two Options:
Set DMX address to “0” or disconnect cable and turn power off and on.