JK Audio RemoteMix Sport User Manual

Page 3

Your new JK Audio product has been registered with the Federal
Communications Commission (FCC). This product complies with
the standards in Part 68 of the FCC rules.

Connection and use with the nationwide telephone
network

The FCC requires that you connect this telephone equipment
to the national telephone network through a USOC RJ-11C
modular telephone jack.

This equipment may not be used with Party Line Service or
Coin Telephone Lines.

This equipment is hearing aid compatible.

Information for the telephone company

Upon request from your local telephone company, you are
required to provide the following information:

a) The "line" to which you will connect the telephone

equipment (that is, your telephone number), and

b) The telephone equipment's FCC registration number.

This can be found on the bottom of your t e l e p h o n e

equipment,

and,

The ringer equivalence number (REN) for this

equipment. The REN is used to determine the quantity of
devices which will be connected to the telephone line.
Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In most,
but not all areas, the sum of the RENs should not exceed 5.0.
To be certain of the number of devices that may beconnected
to the line, as determined by the total RENs, contact the local
telephone company.

3. Repair

Instructions

If it is determined that your telephone equipment is
malfunctioning, the FCC requires that it not be used and that it

FCC Registration

Operation

1. Connect your audio equipment, microphones, cue input, and

headphones to the input and output jacks on RemoteMix Sport.

2. (a) Connect the jack marked "Phone Line" to any standard

analog telephone line, or

(b) Disconnect the handset on an existing telephone and plug

the coily cord from the phone into the PBX handset
interface jack on RemoteMix Sport, or

on your cellular phone using the supplied cable.

3. Turn on the power switch, flip the "Phone Line" switch to "Dial/

Talk", flip the keypad switch to “On” (only if dialing with the Re-
moteMix Sport keypad) and dial your call. You are now ready
to broadcast or record a telephone interview

2. (c)

Cell Phone con-

nection using wireless
phone cable provided

2. (a)

Standard analog telephone line

2. (b)

Handset jack on PBX

telephone. Set A-B-C switch
for best audio.

Handset optional. Can
be used to set up a call.