Check list before using the dryer, Preparing to transport the dryer ć step by step – Bosch WTMC6321US User Manual
Page 9
9
The dryer should be level with all
four feet firmly on the ground. The
dryer must not wobble. If the dryer
is not level or if it does wobble, the
feet must be adjusted. Adjust the
heightĆadjustable feet until the
dryer does not rock and is level,
both frontĆtoĆback and
sideĆtoĆside.
11. Connect the exhaust duct to the
exhaust air outlet on the dryer.
12. Insert plug into the wall receptacle.
Check list before using
the dryer
1. Check that steps 1Ć12 have been
implemented properly.
2. Ensure that the dryer is connected
to the power supply.
3. Read the operating instructions to
understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is empty.
q Close the dryer door.
q Switch the dryer to Extra Dry"
and then press the Start
button.
q After 3Ć5 minutes press the
Stop button and open the door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to OFF".
6. If the dryer does not work, switch
the dryer to OFF".
Look in the troubleshooting
section (page 21) of the
OPERATING INSTRUCTIONS and
find the fault.
Preparing to transport the
dryer ć step by step
1. Rotate the program selector
to OFF".
2. Pull out power supply plug.
3. Disconnect the exhaust duct from
the exhaust air outlet on the dryer.
4. Place any accessories in the drum.
5. Close the door and secure with
adhesive tape.
6. Screw the heightĆadjustable feet of
the dryer into the housing to
prevent them from being damaged
during transportation.