beautypg.com

3 operating the mavo-monitor, 1 inserting the battery, 2 preparing the measurement – Gossen Mavomonitor User Manual

Page 4: Operating the mavo-monitor, Inserting the battery, Preparing the measurement

background image

4

GOSSEN Foto- und Lichtmeßtechnik

3

Operating the MAVO-MONITOR

3.1

Inserting the Battery

The battery compartment is to be found at the
back of the unit.
To open the compartment turn the screw through
90° using a coin so that the lid pops open.
Insert the included battery into the battery com-
partment.
Make sure you insert the batteries with the right
polarity. Close the battery compartment.

Attention
Only use new batteries or rechargeable accus
according to IEC 6 LF 22!

3.2

Preparing the Measurement

Connect the measuring sensor to the
MAVO-MONITOR. Switch the instrument on using
the ON/OFF switch and carry out a segment test.

Segment test
Move the slider switch to the position
“Segm.-Test”. The display is working properly
when the readout 1888 appears for 1.5 seconds
(followed by an undefined readout).
If not, the instrument must be returned to our
Service Department.

This manual is related to the following products: