Glyph GT 062 - Manual (Page 6)

5. Select the desired configuration on the following screen and click the Change button.
6. The next window requires that you verify the change request. Click OK to change the drive configuration.
NOTE: ALL DATA ON THE DRIVES WILL BE DESTROYED.
7. The next window reports that the drive configuration has changed. After a few seconds the system will
update, and Glyph Manager will display the new drive configuration. Click OK in this window.
8. At this point you may see the Mac OS Disk Insertion window. If you change to JBOD mode, you may see
two of these windows. Now that the drive configuration has changed, Mac OS has re-discovered the GT 062
and prompts you to format the newly configured device. If you see the window below, click Eject. If you do
not see this message, simply go to step 9.
9. Power off the GT 062, unplug the FireWire cable, plug the cable back in, then power it back on again. This
is important to force Mac OS to “forget” any current drive information.
10. If you get the Disk Insertion dialog box, this time click Initialize which will open Disk Utility. If not, open
Disk Utility from your System Volume > Applications Folder > Utilities Folder, and format the new volumes.
Mac OS X formatting instructions can be found later in this manual.