GBC 44DT - Manual (Page 30)

Operating Instructions
Page 6-14
44DT
Press RUN and immediately grasp the release
liner for separation as the board is pulled into the
rollers.
Do not allow the release liner to be pulled into
the rollers.
After the board has cleared the rollers press
STOP.
T
IPS
F
OR
T
HREADING
P
RESSURE
S
ENSITIVE
A
DHESIVE
(PSA) F
ILM
Use kraft paper for one-sided lamination.
Refer to Fig. 6-19 for the proper film
configuration.
Whenever possible, pull the remaining web
of film out the back of the laminator after the
finished item has been removed.
M
OUNTING
P
RE
-T
REATING
B
OARDS
You may wish to pre-coat mounting boards ahead of
time with PSA mounting film.
Fig. 6-27. Laminator Set Up for Pre-treating Boards With
Single Liner Mounting Film.
7.
8.
•
•
•
Fig. 6-28. Laminator Set Up for Pre-treating Boards With
Double Liner Mounting Film.
To pre-treat boards:
Load the laminator as shown in Fig. 6-27 or 28.
Adjust the roller pressure handle to the proper
mounting setting.
Start a leader board into the rollers.
Press RUN.
Continue feeding one board after another.
Butt the leading edge of the next board up
against the trailing edge of the previous one.
Press STOP when the last board exits the
machine.
M
OUNTING
O
NLY
This process requires a decalled item with PSA
mounting adhesive. Refer to the To run the second
pass instructions in the Decaling In Two Passes section
of this chapter. An alternative method is to use a PSA
pre-treated board, which is described in the Mounting
and Overlamination section.
1.
2.
3.
4.
5.
6.
PSA mounting film
Board