Applications, Tips for pre-coating boards, Tips for using the rear rollers – GBC 62fm User Manual
Page 30: 62fm l, Operating instructions, Aminator

Operating Instructions
10
62FM L
AMINATOR
A
PPLICATIONS
T
IPS
FOR
P
RE
-
COATING
B
OARDS
Load the laminator as shown.
Fig. 6-19. Pre-coating Boards With Mount Adhesive.
Remove the chill idler.
Set the roller pressure handle to the correct
thickness.
The width of the roll should not exceed the
width of the board by more than ½ in. (1.3
cm).
Use a leader board to start the run and a
trailer board to finish the run.
Using the pull rollers will allow you to leave
gaps between boards.
If not using the pull rollers, have the boards
nearby to butt end to end during feeding.
•
•
•
•
•
•
•
T
IPS
FOR
U
SING
THE
R
EAR
R
OLLERS
If the front rollers are heated, you may perform
certain applications from the rear operating position
of the laminator. You may perform mounting
applications, pre-coating applications, and single
side applications from the rear of the machine.
Fig. 6-20. Running From the Rear.
Remove the chill idler if using boards.
Ensure the safety shield is located in the
rear position and latched or use the foot
switch for slow speed operation.
Ensure the
REAR CONTROLS have been
enabled.
Use the foot switch to run the laminator.
•
•
•
•
Trailer board
Leader board
Board
Mount adhesive
Mounting film
PSA film
Release liner