GBC 62fm - Manual (Page 14)

Operating Instructions
5-2
62FM L
AMINATOR
S
PEED
When pressed, permits increasing or decreasing of
speed by turning the
MASTER DIAL and is indicated
on the control panel display. Range is 1 to 10.
R
EV
When pressed and held, reverses roller movement to
clear film jams and wrap-ups.
S
TOP
Stops the movement of the rollers.
R
UN
When pressed, activates rollers for normal operation.
R
EWINDER
S
ELECTION
S
WITCH
These switches enable the operator to control the
function of the upper rewind/unwind shafts.
Fig. 5-2. Rewinder Selection Switches.
I In this position, turns the power on to the upper
front rewind/unwind shaft.
In this position, neither the upper front or upper
rear rewind/unwind shaft is selected for motor power.
II In this position, turns the power on to the upper
rear rewind/ unwind shaft.
U
PPER
R
EWINDER
D
IRECTION
S
WITCH
This switch enables the operator to control the
direction of the upper rewind/unwind shafts.
FWD: In this position, the motor runs in a forward
direction.
STOP: Stops the rewinder motor for the
rewind/unwind shaft selected.
REV.: In this position, the motor runs in a reverse
direction.
L
OWER
R
EWINDER
D
IRECTION
S
WITCH
(Not shown.) This switch enables the operator to
control the direction of the lower rewind/unwind
shaft.
FWD.: In this position, the motor runs in a forward
direction.
STOP: Stops the rewinder motor for the
rewind/unwind shaft selected.
REV. In this position, the motor runs in a reverse
direction.
Rewinder
switch
Upper
rewinder
direction
switch