GBC EBA 721-05 LT - Manual (Page 15)

- 15 -
05-01
07
DIN894
24
4. Maintenance
Danger!
- Maintenance work may only be performed
by trained staff.
- Before replacing the blade or cutting stick
switch off the main switch.
- Disconnect from the mains before
starting any service work or before
removing the cover.
Safety check
The safety regulations are according to the
regulations of the country where the cutting
machine is operated. The manufacturer
recommends a safety check is made every
5 years by an authorised service team.
4.1 Setting the cutting depth
If the last sheet of paper is not completely cut, the
cutting depth must be adjusted.
- Lower the blade depth adjustment (27) 1/12
using a spanner.
- Remove spanner.
- Perform cutting test as described.
If the cutting stick (26) is very worn it must be
turned.
Warning!
Do not cut into the cutting stick too deep as
this shortens the life time of the blade.