beautypg.com

Black & Decker CS1000L User Manual

Page 10

background image

10

TO USE LASER LINE ON SAW

• Mark the line that you intend to cut on

the workpiece.

• Adjust the depth and angle of cut as

required.

• Switch the laser to the “ON” position

and project the laser beam as shown in
figure 14.

• Plug in the saw and squeeze the

trigger.

• Allow the blade to reach maximum

speed and place the saw on the
workpiece. Align the laser line with the
mark on the workpiece and slowly push
the saw forward keeping the laser line
on the mark.

• Upon completion of the cut, release the

trigger and allow the saw blade to
come to a complete stop before
switching off the laser.

TO USE LASER OFF SAW

The laser can be removed from the saw

and used for a variety of different
applications.
To use the laser off the saw, fold down
the front leg as shown in figure 15.

The laser can also be used in conjunction
with the protractor in three different ways:
(1)

360 degrees - To project the laser line

any direction in a complete circle, 1st
retract the front leg and then insert the
two back legs into the groove of the
protractor as shown in figure 16.

(2)

Fixed Position - To use the laser in

the fixed position, place the rear legs in
the holes on the protractor. Refer to
figure 17 for the angles created when
using the laser in these holes.
(3)

Protractor on Edge of Workpiece -

To use the laser on the edge of your
workpiece, rotate the legs of the
protractor so that they are straight up and
down as shown in figure18. Place the
protractor against the edge of the
workpiece and center the large hole of
the protractor over the intended line of
cut.

15

16

AA

BB

AA

AA

BB

BB

CC

CC

DD

DD

EE

EE

to AA = 0

° Right

to BB = 0

° Left

CC to CC = 90

°

DD to DD = 45

° Left

EE to EE = 45

° Right

17

18

14

631798-01, CS1000L Cir Saw 12/16/05 1:14 PM Page 10