Garden Sun Heater HSS-A-SS THD-2010 - Manual (Page 7)

6
.
Load Head Assembly by inserting hose into pole.
.
Insert Head Assembly into pole.
.
Control knob should be above decal on pole.
.
Attach Head Assembly to pole, and loosely install four
small bolts.
.
Tighten bolts securely.
Step 6 – Install Reflector
WARNING
Remove protective cover before assemble.
Note: If necessary for proper alignment of reflector
sections, loose each screw prior to further assembly and
retighten after sections are aligned.
.
Slide two Reflector
Panels together.
.
Insert one Small
Screw.
.
Slide one Small Flat Washer over threaded end of
screw and screw on Cap Nut loosely.
.
Slide Reflector Plate
onto Reflector Panels.
.
Insert one Small
Screw.
.
Slide one Small Flat
Washer over threaded
end of screw and
screw on Cap Nut
loosely.
.
Repeat procedure to complete the assembly of all four
sections.
.
Fully tighten all of the screws in the rolled edge.
9 Req’d Small Screw s
9 Req’d Cap Nuts 9 Req’d Small Flat Washers