Garden Sun Heater HSS-A-SS THD-2010 - Manual (Page 6)

5
Step 2 – Attach Pole to Support Brackets
Put the upper pole onto the lower pole, using 2pcs
3/16” screws to firmly secure 2pcs pole.The warning
label on the upper pole should be on the same side as
the flat plate of the lower pole.
Install Pole onto three Support Brackets.
Attach Pole to Support Brackets using six large bolts
& six flange nuts.
Fully tighten all of the screws.
Step 3 – Load Cylinder Housing onto Pole
.
Load Cylinder Housing onto Pole.
.
Slide Cylinder Housing down.
Step 4 – Attach Reflector Studs to Screen Cover
.
Insert 3 Reflector Studs & 3 Flat Washers.
.
Tighten studs securely.
Step 5 – Attach Head Assembly to Pole
.
Screw off 4 small bolts.
3 Req’d Reflector Studs 3 Req’d Large Flat Washers
Head Assembly
4 Req’d Small Bolts
6 Req’d Large Bolts 6 Req’d Small Flange Nut