Garden Sun Heater HSS-NG-SS Natural Gas - Manual (Page 8)

7
Step 7 – Attach Reflector Assembly to Studs
.
Support Heater.
.
Slide 3 Large Flat Washers over threaded end of
Studs.
.
Locate Reflector Assembly on 3 studs.
.
Install large flat washers on studs & securely tighten
wing nuts but do not over-tighten!
Step 8 – Connect Hose
.
You must provide natural gas .
Use this heater only with a natural gas vapor withdrawal
supply system.
A minimum supply pressure of 0.12 p.s.i. is required for
the purpose of input adjustment for natural gas.ANSI
Z223.1/NFPA54, Natural Gas and Propane Installation
Code, CSA B149.1, or Propane Storage and Handling
Code, B149.2.
The installation must conform with local codes, or in the absence
of local codes,with National Fuel Gas Code, ANSI Z223.1/NFPA54,
Natural Gas and Propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, B149.2.
A dented, rusted or damaged propane cylinder may be hazardous
and should be checked by your cylinder supplier. Never use a propane
cylinder with a damaged valve connection.
Screw regulator onto gas hose. Do not cross-thread.
Tighten securely.
Attach regulator to hose.
Complete attachment.
6 Req’d Large Flat Washers 3 Req’d Wing Nuts