Garden Sun Heater HSS-NG-SS Natural Gas - Manual (Page 5)

4
Hardware
Picture Qty Description
Used in
Step(s)
4 Medium Bolt 2
9 Small Screw 6
9
Large Flat
Washer
4 & 7
9
Small Flat
Washer
6
4
Large Flange
4 Req’d Large
Flange Nuts
Nut
2
9 Cap Nut 6
3 Wing Nut 7
3 Reflector Stud 4
1 Wrench 1 / 5 / 6
Additional Requirements
The following items are not included, but are necessary for
the proper assembly of your heater. Do NOT attempt to
assemble without proper tools.
Philips screwdriver w/ medium blade.
Adjustable opening wrench.
Leak Detection Solution(Instructions on how to make
solution are included in leak check process.
Note: You must follow all steps to properly assemble
heater.
Installation process
Step 1 – Attach Ground Fixer To Base
4 Req’d Medium Bolts
4 Small Screw 3
...
WARNING
California Proposition 65
Combustion by products produced when using
this product contain chemicals known to the state
of California to cause cancer, birth defects, and
other reproductive harm.
Reverse the base, fix the ground fixer to the base with
bolts and washers like picture shows.
To protect heater from strong wind, anchor the base
securely to the ground with screws.
Firm the ground fixer with nuts.
Fix another two ground fixer with bolts and nuts,
and reverse the base.
3 1 Ground Fixer
3 Req’d Ground Fixers
6 Small Bolt 1
6
6
Small Flat
Washer
1
1 Nut
6 Req’d Small Bolts
6 Req’d Small Flats
6 Req’d Washer Nuts
Step 2 – Attach Post to Base
Put lower post through the hole on the top of base, attach
lowerpost to base using four large bolts.