E-flite UMX Radian BNF - Manual (Page 5)

5 EN
Wing Installation
1. Slide the wing into the wing slot on the
fuselage until the holes line up with the screw
holes on the bottom.
2. Secure the wing using 2 screws.
3. Cut the loop tape (A) into 3 pieces and apply
them around the screws in the battery holder,
as shown.
For a list of compatible DSM2/DSMX
transmitters, please visit www.bindnfl y.com.
CAUTION: When using a Futaba®
transmitter with a Spektrum DSM module, you
must reverse the throttle channel and rebind.
Refer to your Spektrum module manual for
binding and failsafe instructions. Refer to your
Futaba transmitter manual for instructions on
reversing the throttle channel.
Transmitter and Receiver Binding
 Binding Procedure Reference Table
1. Refer to your transmitter instructions for binding to
a receiver.
2. Make sure the fl ight battery is disconnected from
the aircraft.
3. Ensure the transmitter is powered OFF.
4. Connect the fl ight battery to the aircraft. The
receiver LED will begin to fl ash (typically after 5
seconds).
5. Make sure the transmitter controls are at neutral
and the throttle is in the low position.
6. Put your transmitter into bind mode.
7. After 5 to 10 seconds, the receiver status LED will
become solid, indicating that the receiver is bound
to the transmitter. If the LED does not turn solid,
refer to the Troubleshooting Guide at the end of the
manual.
For subsequent fl ights, power ON the transmitter for 5
seconds before connecting the fl ight battery.
A