E-flite UMX Pitts S-1S BNF Basic - Manual (Page 9)

9
EN
Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller
while the fl ight battery is connected to the ESC.
Personal injury could result.
Propeller
1. Remove the spinner (A) from the propeller.
Since the propeller and spinner are glued
together, glue residue will need to be cleaned
from the spinner or propeller when these parts are
used again.
2. Carefully remove the screw (B) and propeller
(C) from the motor shaft.
Motor
1. Remove the battery hatch by gripping the front
of the hatch, then pulling it up and away from
the fuselage.
2. Disconnect the motor wire connector from
the ESC/receiver connector.
3. Remove the screw (D) and motor (E) from the
motor mount.
4. Remove 3 screws (F) and the prop adapter (G)
from the motor. The motor magnet may attract
screws to the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the ESC/
receiver.
• The propeller size numbers (5.75x2.25) must
face out from the motor for correct propeller
operation.
• Ensure the propeller adapter and motor mount
are fully connected to the motor.
A
B
C
E
D
G
F