E-flite Extra 260 3D Profile - Manual (Page 18)

 2. Place the 4 1 /
2
" (113mm) carbon rods on the
bottom of the stabilizer to the bottom of the
vertical fuselage. There is a notch in the fuselage
for the rods to rest in. Make sure the rods are
touching each other as well as the carbon blade
spar. Use foam-safe CA to glue the rods at the
fuselage ONLY.
 3. Check the alignment of the fin to the stabilizer.
They should be perpendicular to each other.
Check that the rods in the stabilizer are
touching. Use foam-safe CA to glue the rods
into position after checking alignment and that the
rods are touching.
18