E-flite UMX ASK-21 BNF - Manual (Page 6)

6
EN
Wing Installation
1. Lift the front of the canopy (A) and pull it
forward off the fuselage.
2. Align the 4 holes in the wing (B) with the 4
screw posts in the fuselage.
3. Secure the wing to the fuselage by fully
tightening the 4 included screws (C).
4. Connect the aileron leads to the aileron
ports on the receiver. Left aileron servo needs
to be connected to the front port (D), right
aileron servo needs connected to the rear port
(E). The servos leads are labeled “L” and “R”
for your convenience.
5. Be sure to check proper control directions
before your first flight. You should not need to
reverse any control surfaces.
6. Reinstall the canopy on
the fuselage.
Disassemble in reverse order.
A
C
B
E
Top View
D