E-flite Carbon-Z Cub PNP - Manual (Page 14)

EN
®
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing at the root.
This CG location has been determined with the recommended Li-Po battery
(EFLB32006s30) installed in the middle of the battery compartment.
120mm
back from
leading edge
at the root.
Control Direction Test
Move the controls on the transmitter to make sure the aircraft control surfaces
move correctly and in the proper direction or reverse a servo.
After performing the Control Test, correctly set the failsafe. Make sure the
transmitter controls are at neutral and the throttle and throttle trim are in the
low position, then rebind the airplanes to your transmitter. If the receiver loses
its connection to the transmitter, the failsafe will drive the servos to the settings
made at binding.
Control Horn and Servo Arm Settings
The tabe to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settigns before making changes. Factory Settings
Horns Arms
Elevator
Rudder
Ailerons
Flaps
14