E-flite A6M5 Zero 300 BNF Basic - Manual (Page 6)

6
EN
1. Turn over the model so the bottom of the
fuselage faces up.
2. Carefully install the micro connector of the
aileron servo (A) into the AIL port of the
receiver (B).
NOTICE: When disconnecting the servo connectors,
do not pull on the servo wires. Use a screwdriver
or pliers to break the friction fi t of the servo
connectors. Failure to do so could result in damage
to the servo wiring.
3. Insert the 2 wing pins (C) into the holes in the
front of the fuselage. Connect the back of the
wing to the fuselage.
NOTICE: DO NOT crush or otherwise damage wiring
when installing the wing on the fuselage.
4. Turn the aircraft right side up. Carefully use the
o-ring tool (D) to pull the o-ring (E) over the
hook in the fuselage (F).
NOTICE: Pulling too much on the O-ring can
damage the O-ring connector in the wing, requiring
replacement of the wing.
Tip: Before fl ying, always ensure the O-ring is in
good condition. Replace a worn or infl exible O-ring.
5. Install the canopy on the fuselage.
Installing the Wing
ELE RUD
AUX 1
THR AILE
GEAR
NANOLITE RECEIVER 2048 2.4GHz DSM® TECHNOL OGY
BIND
A
A
B
C
D
E
F