Beckett CG10B - Manual (Page 4)

Burner Start Up Information & Test Data
Beckett Model ____________________ Serial Number_______________________
Job Location_____________________________________________________________
Start Up Date_____________ Company Name_________________ Technician Name________________
Type of Gas: NAT____
Propane____
Gas Pressure at Train Inlet Flame Signal Readings
Draft @ Breech
Burner off position ______w.c Low Fire _______DC volts
High Fire _______DC volts High Fire_________w.c
Gas Pressure Train Inlet O2 Net Stack Temperature
Light-Off ________w.c Light-Off _______%
High Fire ________w.c High Fire _______% High Fire _________degrees
Gas Pressure at Burner CO Combustion Efficiency
Light-Off ________w.c Light-Off _______%
High Fire ________w.c High Fire _______% High Fire _________%
Power Supply Input Rate BTU/HR Air Damper Settings
Volts____ PH____ Hz____ Shutter___________
High Fire_______ Band___________
Control Settings :
Operating Control Cut/Out Limit Control Cut/Out Setting Low/High Gas Pressure
____________________
________________________ _________/___________
Operating Control Cut/In Setting Limit control Cut/In Setting
_______________________ _______________________
Checked for Proper Operation
YES NO Checked for Proper Operation YES NO
Low water cut off Barometric Damper
High water cut off Boiler Room combustion air
Flame Safeguard control ignition failure All gas lines checked for leaks
Flame Safeguard control main flame failure Gas lines and controls properly vented
Burner air flow switch Other system components specify
Notified___________________________ of the following system deficiencies__________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________