Britax Boulevard - Manual (Page 15)

13
Push child restraint firmly into vehicle seat while
pulling each LATCH strap tight (fig. E).
Verify all connections are secure and that restraint
is stable. The restraint is secure when it cannot be
moved front-to-back or side-to-side more than 1”
(2.5 cm.) at belt path. If restraint is not secure, repeat
procedure or use an alternate seating location.
Britax recommends use of the Versa-Tether® to
improve installation. See pages 23-26.
The back angle of the child restraint should be 30º-
45º from vertical (not to exceed 45º from vertical)
when car is parked on a level surface (fig. F).
The proper recline angle can be achieved by placing a
rolled towel or pool noodle in crease of vehicle seat to
help level child restraint’s base.
If there is a problem stabilizing restraint, tighten tether
as described on page 24 using anchor point 3.
Removal
Disconnect the Versa-Tether from tether anchor, if
attached. While pushing the restraint firmly into the
vehicle seat, press the red release buttons on the
LATCH connectors to release. When not in use, always
store the LATCH connectors and Versa-Tether.
7�
8�
•
•
•
•
Installation: Rear Facing
D
E
F
WARNING! Do not raise restraint
off front edge of vehicle seat. Doing
so will reduce protection for your child
and may damage recline adjustment.