Bowflex TreadClimber 3000 - Manual (Page 13)

Assembly Manual 9
The treadles might unlock during workout if they are not fully engaged.
Assembly
Step 5: Attach the Drive Belt
Parts:
• TreadClimber ® Base and Treadle assembly from Step 4
• (1) Drive Belt
Tools:
• 3/16” Hex Key (included)
5-1 Position the drive belt over the roller pulley and the motor
pulley (See Figure 5-1).
5-2 Make sure that the belt is installed correctly into the grooves
of the pulleys (See Figure 5-2).
5-3 Remove the motor shipping bolt from the motor pan with
the 3/16” hex key (See Figure 5-3).
Note: Removing the shipping bolt will make the drive belt tight with
spring-loaded tension. Be sure to keep the bolt in a safe place
in case the machine must be disassembled for shipping or part
replacement.
5-4 Put the unit in the upright position.
Figure 5-1
Figure 5-2
Figure 5-3
Figure 4-1
Lever in locked position
Step 4: Lock the Treadles
Parts:
• TreadClimber ® Base and Treadle assembly from Step 3
4-1 Line up the treadles parallel to each other.
4-2 Move the locking lever down and to the left and then up into
the locked position until it clicks (See Figure 4-1).
4-3 From the front of the machine, press down on each treadle
individually until they lock into the down position.