Metrohm Flow Cell for Bioscan – 6.5331.0X0 - Manual (Page 9)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 2 Installation
IC Equipment Set Flow Cell for Bioscan ￭￭￭￭￭￭￭￭ 3
2 Installation
Caution
Never switch on the flow cell when it is..
￭ ..not being rinsed through with a conducting eluent at the time; or
￭ ..not completely connected; or
￭ ..moist on the outside so that a short circuit could occur between
the connections of working eleoctrode and auxiliary electrode.
8
1
2 3
4
5 6 7
Figure 1 Parts and connections of flow cell
1 Reference electrode connection
For black electrode cable (6.2156.000). 2 Inlet for eluent
Connection of PEEK capillary by 6.2744.130
KELF pressure screw only. PEEK pressure
screws may damage the threads of the cell.
3 Auxiliary electrode connection
For blue electrode cable (6.2156.000). 4 Working eleoctrode connection
For red electrode cable (6.2156.000).
5 Outlet for eluent
Connection of PEEK capillary by 6.2744.130
KELF pressure screw only. PEEK pressure
screws may damage the threads of the cell. 6 Mounting screws (4x)
7 Distance piece 50 µm (6.1254.020)
Defines the volume of the cell.
8 Check marks
For correct alignment of the top and bottom
part of the flow-through cell.