Metrohm Flow Cell for Bioscan – 6.5331.0X0 - Manual (Page 7)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ 1 Introduction
IC Equipment Set Flow Cell for Bioscan ￭￭￭￭￭￭￭￭ 1
1 Introduction
1.1 Description
The flow cell is used for amperometric detection with the Bioscan measur-
ing instruments. The flow cell's construciton is based on the Wall-Jet-Prin-
ciple. According to the Wall-Jet-Principle the inlet is positioned exactly
opposite to the working eleoctode, which allows for optimum measuring
perfomance.
The flow cell is available in four versions:
￭ Gold flow cell (6.1254.010)
￭ Glassy carbon flow cell (6.1254.050)
￭ Platinum flow cell (6.1254.060)
￭ Silver flow cell (6.1254.070)
For a more detailed description of the specification and intended use of
the individual cells, please see (see Chapter 3, page 6).
1.2 About the Documentation
Caution
Please study this documentation carefully before you start to use the
instrument. The documentation contains information and warnings that
must be observed by the user in order to guarantee the safe use of the
instrument.
1.2.1 Symbols and conventions
The following symbols and styles are used in this documentation:
Cross-reference to figure legend
The first number refers to the figure number, the
second to the instrument part in the figure.
Instruction step
Carry out these steps in the sequence shown.
Warning
This symbol draws attention to a possible life hazard
or risk of injury.