Briggs & Stratton Ferris 5900619 - Manual (Page 34)

32 www.ferrisindustries.com
Maintenance
LUBRICATION
Lubricate the unit at the locations shown in Figure 20
through 24.
Grease:
Use grease fittings when present. Disassemble
parts to apply grease to moving parts when
grease fittings are not installed.
Not all greases are compatible. Ferris Red Grease
(P/N 5022285) is recommended, automotive-type
high-temperature, lithium grease may be used when
this is not available.
Regular Maintenance
Figure 20. Deck Lift Linkage Pivots
Figure 21. Deck Lubrication
RE-PACK RE-PACK
BEARINGS BEARINGS
ANUALLY ANUALLY
RE-PACK
BEARINGS
ANUALLY
Figure 22. Front Caster & Wheel
Figure 23. Control Handle Pivots & Seat Pivots
Oil:
Generally, all moving metal parts should be oiled
where contact is made with other parts. Keep oil
and grease off belts and pulleys. Remember to
wipe fittings and surfaces clean both before and
after lubrication.
Figure 24. Gearbox Drive Idler Pivot