Briggs & Stratton Ferris 5900619 - Manual (Page 24)

22 www.ferrisindustries.com
Operation
ADVANCED DRIVING
Executing an End-Of-Row Zero
Turn
Your Zero Turn Rider’s unique ability to turn
in place allows you to turn around at the end
of a cutting row rather than having to stop
and Y-turn before starting a new row.
For example, to execute a right end-of-row
Zero Turn:
1. Slow down at the end of the row.
2. Move the LEFT ground speed control
lever forward slightly while moving the
RIGHT ground speed control lever back
to center and then slightly back from
center.
3. Begin mowing forward again.
This technique turns the rider RIGHT and
slightly overlaps the row just cut —eliminating
the need to back up and re-cut missed grass.
As you become more familiar and
experienced with operating the Zero Turn
rider, you will learn more maneuvers that will
make your mowing time easier and more
enjoyable.
Remember, the more you practice, the
better your control of the Zero Turn will
be!
Practice Turning In Place
To turn in place, “Zero Turn,” gradually move one
ground speed control lever forward from neutral and
one lever back from neutral simultaneously. Repeat
several times.
NOTE: Changing the amount each lever is pulled—
forward or back, changes the “pivot point” you turn on.
Practice Turning Around a Corner
While traveling forward allow one handle to gradually
return back toward neutral. Repeat several times.
NOTE: To prevent pivoting directly on the tire tread, it
is best to keep both wheels going at least slightly
forward.
Figure 7. Turning Around a Corner Figure 8. Turning in Place
Figure 9. Executing an End-Of-Row Turn
Operation
Executing
Turns Turning
In-Place