Metrohm 781 pH/Ion Meter: Operation via RS-232 - Manual (Page 21)

2 Remote control commands
780/781 pH/Ion Meter - Operation via RS232
19
&Setup
Object Description Input range
&Setup Settings for the operating mode
: ├
.Keycode Send key code ON, OFF
├
. Trace Message on changed values ON, OFF
├
.Lock Lock key functions
│ ├
.Keyboard Lock all keyboard keys ON, OFF
│ ├
.Config Lock key ON, OFF
│ ├
.Parameter Lock key ON, OFF
│ ├
.Cal Lock key ON, OFF
│ ├
.UserMeth Lock user method functions
│ │ ├ .Recall Lock recall function ON, OFF
│ │ ├ .Store Lock store function ON, OFF
│ │ └ .Delete Lock delete function ON, OFF
│ ├
.CalData Lock key ON, OFF
│ ├
.Mode Lock key ON, OFF
│ └
.ElTest Lock key ON, OFF
├ . AutoInfo Automatic message for status changes
│ ├
.Message Definition of message
│ │ └ .DateTime Date and time of occurrence ON, OFF
│ ├
.P When mains is switched on ON, OFF
│ ├
.G When method id started ON, OFF
│ ├
.R When "ready" ON, OFF
│ ├
.S When stopped ON, OFF
│ ├
.E Error ON, OFF
│ ├
.Re Request after start ON, OFF
│ ├
.D When drift condition OK ON, OFF
│ ├
.I Change upon inputs ON, OFF
│ └
.O Change upon outputs ON, OFF
├ . InputAssign Assignment of I/O line inputs
│ ├
.pH Mode pH 0...1...15
│ ├
.T Mode T 0...2...15
│ ├
.U Mode U 0...3...15
│ ├
.pHcal Start pH calibration 0...5...15
│ ├
.ElTest Start electrode test 0...6...15
│ ├
.Conc Mode Conc 0...8...15
│ ├
.ConcCal Start concentration calibration 0...9...15
│ └
.Enter key 0...15
└ . Graphics Changing graphics output
├
.Grid Grid on curve ON, OFF
├
.Frame Frame around curve ON, OFF
├
.Recorder Length of axis
│ ├ .Right Length of measured value axis 0.4...0.8...1.0
│ └ .Feed Length of paper drive axis 0.4...1.0
└
.InstrNo Device identification $G
└
.Value Input of device identification 8 ASCII char.