Vizio S5430w-C2 - Quickstart Guide - Manual (Page 15)

15
Function LED Behavior Description
DTS TruSurround
On/Off
Surround On:
Surround Off:
Press the Next/Previous button to enable/disable DTS TruSurround. When
enabled (On), all inputs will produce virtual surround sound. When disabled
(Off), all sources will playback on 3 channels (Left, Center, and Right).
DTS TruVolume
On/Off
TruVolume On:
TruVolume Off:
Press the Next/Previous button to enable/disable TruVolume. When enabled
(On), TruVolume provides a consistent and comfortable volume level for a more
enjoyable listening experience.
Night Mode On/Off
Night Mode On:
Night Mode Off:
Press the Next/Previous button to enable/disable Night Mode. When enabled
(On), the Sound Bar will lower bass frequency levels to provide a more quiet
environment (ideal for apartment living and homes with sleeping children).
AV Delay
Two center LEDs
indicate minimal
delay.
Press the Next/Previous button to increase/decrease the amount of audio delay.
The LED indicators will move to the right with increasing audio delay levels.
TV Remote
TV Remote On:
TV Remote Off:
Press the Next/Previous button to enable/disable VIZIO TV Remotes. When enabled
(On), you can use a VIZIO TV remote control to turn on the Sound Bar (using the TV
Volume Up button) and control volume.
Eco Power On/Off
Eco Power On:
Eco Power Off:
Press the Next/Previous button to enable/disable Eco Power Mode. When enabled
(On), the Sound Bar will go into standby after a period of inactivity. The sound bar
will automatically turn off when no audio signal is detected. Off disables this feature.
Note: Enable this function if using a TV remote to control the sound bar.
Program Remote
---
Press the Next/Previous and Play buttons to toggle and select and program your
TV remote to control the Volume Down, Volume Up, and Mute functions on your
Sound Bar. See Programming the Sound Bar on page 16.
Reset
---
Press the Next/Previous and Play buttons to select and reset your remote and
Sound Bar to the factory default settings. All paired Bluetooth devices will be
unpaired. All programmed IR remotes will also be removed. See Resetting to
Factory Default Settings on page 17.
When a Dolby
Digital or DTS
signal is detected
Dolby Digital Logo
DTS Logo
Dolby Digital and DTS are only available on either the HDMI, Digital Coaxial Audio
In, or Digital Optical Audio In inputs. When a Dolby Digital or DTS signal is detected,
the Dolby Digital or DTS logo will light up for 5 seconds before fading away.
Surnd
TruVol
Night
VZtvRmt On
EcoPwr On
Prg Remote
Reset No
AV Delay