Dynalite Power Pack - Manual (Page 6)

M500Wi / M1000Wi / M2000Wi
Power Packs
AC On / Off Power Switch - Turns power
pack on and off.
Two stop Variator Conrol - Fine-tune your
power settings in 1/3 stop detented incre-
ments. Used in combinations, the power
control switches and Variator provide a
total of 18 different power settings with a
single flash head, going as low as 15 watt/
seconds.
Power Control Switches – Three position
full/half/quarter power switches provide
power settings over a three stop range per
channel. (These can be trimmed using the
Variator or combined using the Ratio out-
put switch.)
Tri-color L.E.D. Power Indicators – Tell at
a glance how much power your pack is set
to deliver. Red, Orange and Green lights in-
dicate full, half and quarter power, respec-
tively.
Proportional Modeling Light Controls-
Five position proportional modeling light
switch allows you to control the ratio of
your modeling light for pre-visualization.
Flash head fans always run at full speed re-
gardless of switch position.
Flash Head Outlets – The pack is capable of accepting up to four heads and each is outlet is arc protected. This means that it is completely safe
to plug and unplug flash head cables into the outlets even while the pack is on.
Modeling Light Delay Circut - (M2000 Wi only) Delays the modeling light from coming back on after flash for 1, 2, 4 or 8 seconds. It is especially
useful when you are dragging the shutter so the modeling lights will not effect exposure. It also redirects the power from the pack when
recycling as the modeling lights draw an additional 2 amps of power each.
AC Power Cord Socket and Circuit Breaker - Offers easily reset-able protection.
Ratio/Combined Output Switch - An indicator light tells you whether your power is routed symmetrically or asymmetrically between the
“A” and “B” flash head outlet banks.
Ready Light/Test Switch - When lit the pack is fully charged. This button can also be used to manually trigger the pack.
Sync, WEIN slave-eye and Pocketwizard selector switch - Can be triggered by sync cord, any flash and will also respond to most infra-
red triggers or optional Pocketwizard radio slave.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
5.
12. Audible Ready Indicator Switch- Get audible confirmation that the pack is fully recycled to full power.