Dolgin Engineering vDOUBLER SPL Manual - Manual (Page 2)

 Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • (781) 863-1813 • www.dolgin.net 1
Introduction
The vDOUBLER-SPL is electrically compatible with all common 7.2V Li-Ion camera batteries. The modular
design allows for different battery models to be used when the appropriate adapter plate is fitted. With the
appropriate power cord, the vDOUBLER-SPL can power a monitor, camera or any other device using 12V
DC power.
Batteries
The vD-SPL adapter accepts Sony L/M (VX2xx or similar), Panasonic
DVX100/HVX200/HPX170/HMC150, and Canon BPxx (XL/GL) style batteries. The adapter must be
configured with the appropriate plate to match the battery style.
Operation
Mount a fully charged battery on the vD-SPL adapter. The LED will illuminate. Connect the DC cable to
your device.
Status LEDs
1. Green ON
Battery is fully charged
2. LED blinking 3 times Battery is approximately at 3/4 charge level or less
3. LED blinking 2 times Battery is approximately at 1/2 charge level or less
3. LED blinking 1 times Battery is approximately at 1/4 charge level or less
4. LED strobs Battery is discharged
* To extend batteries service life avoid running them down to below 1/4 level
Specification
•
Input Voltage 6.5V-8.4V
•
Output Voltage 12V
•
Output Current up to 2A
•
Efficiency ~90%
•
Overload/short circuit protection set at 2.5A
•
Smart LED charge level indicator
Warning: This device is designed to power medium level power devices (7”-9” LCD
monitors, etc). Do not try to power lights above 20W or any other power hungry devices.