Dolgin Engineering EX-V adapter manual - Manual

 Dolgin Engineering 1019 Massachusetts Ave. Lexington, MA 02420 • (781) 863-1813 • www.dolgin.net 1
EX-V Adapter
Cable length adjustment
The cables length can be adjusted to fit your configuration by following the steps below:
1. Squeeze the small insert of the strain relief using a pair of pliers as shown on the
picture.
2. Pull out the strain relief.
3. Adjust the wire length either by pulling it out or pushing it in into the adapter.
4. Replace the strain relief.
LIMITED WARRANTY
Each DOLGIN ENGINEERING product is built to exacting standards and subject to extensive testing prior
to shipment.
DOLGIN ENGINEERING products are guaranteed for a period of 2 years from the date of purchase.
This warranty covers only defects in materials or manufacturing and does not cover damage caused by
misapplication, modification, abuse, or tampering. Equipment which has been damaged, has parts missing,
or is beyond the warranty period is subject to full factory repair charges. No liability is assumed for any
special, incidental, or consequential damages including but not limited personal injury and property damage,
with the sole exception of other than product repair or replacement. No other warranty, written, oral, or
implied is assumed or extended by
DOLGIN ENGINEERING. Product may be repaired or replaced at
factory option. This warranty may contain exclusions or give you additional rights, which may vary from state
to state.
Should you require technical assistance, please contact
DOLGIN ENGINEERING at (781) 863-1813